Parameter Description Setting
Identity
authenticatio
n mode
and
Encryption
mode
The first parameter specifies the identity
authentication mode used on the Wi-Fi
network. The second parameter specifies
the data encryption mode corresponding
to the identity authentication mode
adopted.
l OPEN: If you select this option for
Identity authentication mode, the
values available for Encryption
mode are NONE and WEP.
l SHARE: If you select this option for
Identity authentication mode, the value
available for Encryption mode is
WEP.
l WPA-PSK: If you select this option
for Identity authentication mode, the
values available for Encryption
mode are TKIP and AES.
l WPA2-PSK: If you select this option
for Identity authentication mode, the
values available for Encryption
mode are TKIP and AES.
l
The default value of Identity
authentication mode is
OPEN.
l The default value of
Encryption mode is
NONE.
NOTE
When the TE30 is connected to a
VPM220, you must set Identity
authentication mode to WPA-
PSK or WPA2-PSK.
Password
Specifies the password used by other
devices to connect to your TE30.
The required password varies
depending on your settings of
Encryption mode. If you set
Encryption mode to NONE,
the Wi-Fi network provided by
your TE30 is open to everyone.
Local IP
address
and
Subnet mask
Specify the IP address and subnet mask of
your TE30.
Examples:
l Local IP address:
192.168.1.10
l Subnet mask:
255.255.255.0
DHCP Specifies whether your TE30 assigns IP
addresses to devices connected to it.
If you select this parameter, you must also
set Start IP address and End IP
address.
This parameter is deselected by
default.
Start IP
address
and
End IP
address
Specify the IP address segment for the
devices connected to your TE30.
Examples:
l Start IP address:
192.168.1.10
l End IP address:
192.168.1.157
HUAWEI TE30 Videoconferencing Endpoint
User Guide 3 Network
Issue 01 (2013-03-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
22
To Next Page
Loading...
Need help?
General
