13
2. Choose Home tab, click Connect to the Internet. Select your Internet connection mode.
Refer to the following table to configure the network connection.
3. Set WLAN parameters.
> If you selected Connect with user account， enter the parameters provided by your
Internet Service Provider (ISP) and click Next.
> If you selected Connect with no user account,click Next.
If you selected Connect with user account or Connect with no user account, the
computer automatically connects to the Internet as long as the router is working properly.
+
4. Choose Home tab, click Set Up WLAN， set WLAN parameters, click Save.
To obtain the default SSID and key, check the label on the rear panel. To better secure your
WLAN, promptly change the SSID and key.
Setting Dial-Up Connection Parameters
When the WS330 works in Bridge mode you need to perform this operation. Otherwise you do not need
to perform this operation.
Scenario Connection Type
When you are unsure of the network connection you subscribed to,
you can select this mode that the device will detect the network
connection automatically.
Connect automatically
The account name and password are provided by your Internet
Service Provider (ISP).
Connect with user account
No parameter is provided by your ISP. The IP address is
automatically assigned by the ISP.
Connect with no user
account
To Next Page
Loading...
Need help?
General
