20
If any days are selected as non-water days at the
bottom of the display, the Interval Day watering
will exclude those days. For example, if the Interval
Days are set at 5 and Monday is a non-water day, the
controller will water every 5th day, but never on a
Monday. If the interval water day falls on a Monday
and Monday is a non-water day, the program would
not water for 5 more days, resulting in no irrigation
for 10 days total.
Note
hunter.help/P2C
Setting a Watering Schedule (continued)
Selecting Interval Watering
Use this feature to set a consistent irrigation schedule based
on a number of days between watering, as opposed to
specic days of the week.
1. Turn the dial to the WATER DAYS position. The water
drop above Monday should ash.
2. Press the → button until EVEN days are selected,
then press the → button one more time. The display
will change to the interval mode and the Interval Day
number will ash.
3. The display will now show two numbers: the interval and
the days remaining in the interval.
4. The number of days between waterings, or the interval,
will ash. Use the + and - buttons to select the number of
days desired between waterings.
5. Press the → button. The days remaining in the interval
are now ashing. Use the + and - buttons to select the
number of days until the next desired watering. One day
remaining means it will water the next day.
6. Aer setting the interval remaining days, press the →
button to select non-water days (optional). Press the ←
and → buttons to select specic days, and press the -
button to designate as a non-water day.
To Next Page
Loading...
Need help?
General
