8 hunter.help/P2C
Installing Station Modules
The Pro-C Controller is supplied with a factory-installed
base module for up to 4 stations. Additional modules may
be added in increments of 3 stations (PCM-300),
9 stations (PCM-900), or 16 stations (PCM-1600). In total,
a conventionally wired system can be expanded up to
23 stations. Additional modules are sold separately.
The Pro-C Controller is also compatible with the EZ Decoder
System (EZDS) for hybrid conventional and two-wire
operations. Add a Pro-C Decoder Module (PC-DM) to enable
control for up to 32 total stations. This system uses the same
EZ-1 Decoders used with ICC2, HCC, and HPC Controllers.
For more installation and programming details, please refer
to the PC-DM Installation Guide.
Installing PCM Modules
The Pro-C Controller is designed with a simple-to-use
Power Lock feature that ensures the modules are energized
and rmly secured into the controller. The Power Lock
can unlock or lock all modules at the same time by simply
pushing the Power Lock slide.
1. Slide the Power Lock into the Power O (unlocked)
position. Insert the PCM modules into the appropriate
sequential position in the controller cabinet.
2. Once all of the modules are in place, slide the
Power Lock into the Power On (locked) position to
energize and secure the modules into the controller.
3. The Pro-C Controller will automatically recognize the
correct number of stations. It is not necessary to press
the reset button on the back of the facepack or cycle
power to the controller.
To Next Page
Loading...
Need help?
General
