Hunter XC User Manual

PROGRAMMInG THE COnTROLLER
The XC display shows the time and day when the controller is idle.
The display changes when the dial is rotated to indicate the specific
programming information to enter. When programming, the flash-
ing portion of the display can be changed by pressing the or
buttons. To change something that is not flashing, press the
or
buttons until the desired field is flashing.
Three programs A, B, and C, each with the ability to have four daily
start times, permit plants with different watering requirements to be
separated on different day schedules.
Setting the Date and Time
1. Turn the dial to the CURRENTTIME/DAY
position.
2.
The current year will be flashing. Use the
or
buttons to change the year. After setting
the year, press the button to proceed to
setting the month.
4. The month and day will be in the display.
The month will be flashing and the icon
will be displayed. Use the
or
buttons
to change the month. Press the
button to
proceed to setting the day.
5. The day will be flashing and theicon
will be displayed. Use the or buttons
to change the day. Press the button to
proceed to setting the time.
6. The time will be displayed. Use the and
buttons to select AM, PM, or 24 hour.
Press the button to move to hours. Hours will
be flashing. Use the and buttons to
change the hour shown on the display. Press
the button to move to minute.
Minutes will be flashing. Use the and
buttons to change the minutes shown on the
display. The date, day, and time have now
been set.
Setting the Program Start Time(s)
1.
Turn the dial to the
START TIMES
position.
3. The factory preset is set on program A. If
necessary, you can select program B, or C
by pressing the button.
4. Use the or button to change the start
time. (The start times advance in 15
minute increments).
6.
Press the
button to add an additional start time, or
button
for the next program.
NOTE: A basic programming rule is that whatever symbol
or character is flashing will be the item programmed. For
instance, if the hour is flashing when setting the time, the
hour can be changed or programmed. For illustration pur-
poses inthis manual, flashing characters areinGRAYtype.
NOTE:One start time will activate all stations sequentially
in that program. This eliminates the need toenter each
station’sstart time. Multiple start timesin aprogram can be
used for separate morning, afternoon, or evening watering
cycles. Start times may be entered in any order. TheXC will
automatically sort them.

Hunter XC Specifications

General

Brand	Hunter
Model	XC
Category	Controller
Language	English