Hunter XC User Manual

PROGRAMMInG THE COnTROLLER (cont.)
Selecting Interval Watering
With this option you can select interval water
ing from 1 to 31 days.
1. With the cursor on EVEN, press the
button once and the
icon will appear and a 1 flashing in the
display. Interval watering schedule appears on the display.
3. Press the or button to select the number of days between
watering days (from 1 to 31 days). This is called the interval.
The controller will water the selected program at the next start time
and will then water at the interval programmed.
Setting Event Day(s) Off
The XC allows you to program a No Water Day(s). This feature is use-
ful to inhibit watering on specific day(s). For example, if you always
mow the lawn on Saturdays, you would designate Saturday as a No
Water Dayso that you are not mowing wet grass.
1. Turn the dial to the WATER DAYS position.
2. Enter an interval watering schedule as described on page 8.
3. Press the button to scroll to the No Water Days at the bottom of the
display. MOwill be flashing.
4. Use the button until the cursor is at the day of the week you
wish to set as a No Water Day.
5. Press the button to set this day as a no water day. The will
illuminate over this day.
6. Repeat steps 4 and 5 until all desired event day(s) are off.
AutomaticWatering
After programming the XC, set the dial to the
RUN
position
to enable automatic execution of all selected watering
programs and start times.
System Off
Valves currently watering will be shut off after the dial
is turned to the SYSTEM OFF position for two
seconds. All active programs are discontinued and
watering is stopped. To return the controller to normal
automatic operation, simply retu
rn the dial to the
RUN
position.
Programmable Rain Off
This feature permits the user to stop all programmed waterings for
a designated period from 1 to 7 days. At the end of the programmed
rain off period, the controller will resume normal
automatic operation.
1. Turn the dial to the SYSTEM OFF position.
Wait for OFFto be displayed.
3. Press the
button as many times as needed to set the number of days off (up to 7 days).
5.
Turn the dial back to the
RUN
position at which
OFF, a
number,
the
and
icons will be
displayed.
The days off remaining will decrease at midnight
each day. When it goes to zero, the display will show
normal time of day and normal irrigation will resume
NOTE:You alsohave the optionin the interval watering
schedule toprogram Odd or Even days off.

Hunter XC Specifications

General

Brand	Hunter
Model	XC
Category	Controller
Language	English