Husqvarna Rider 16 User Manual

English – 17
DRIVING
Driving the machine
1. Release the parking brake by pressing down the
brake pedal.
3. Select the required cutting height (1-9) with the
cutting height lever.
To obtain a uniform cutting height it is important
that the tyre pressures are equal on both front
wheels (60 kPa).
2
1
2. Carefully press down one of the pedals until the
correct speed is reached.
To drive forwards: press down pedal (1).
To reverse: press down pedal (2).

Husqvarna Rider 16 Specifications

General

Engine Manufacturer	Briggs & Stratton
Fuel Type	Gasoline
Transmission Type	Hydrostatic
Drive	Rear-Wheel Drive
Deck Material	Steel