EasyManuals Logo

Husqvarna Rider 16 User Manual

Husqvarna Rider 16
51 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
24 English
Replacing the air filter
If the engine seems to lack power or goes
irregularly the reason may be that the air filter is
clogged.
It is therefore important to replace the air filter at
regular intervals (see maintenance schedule on
page 20 for correct service interval).
1. Fold open the engine cover as described on
page 21.
2. Remove the air filter housings plastic cover by
releasing the wing-nut.
MAINTENANCE
5. Fit the air filter as follows:
Push the pre-filter over the paper filter.
Fit the paper filter with pre-filter in the air filter
housing and tighten the wing-nut.
Replace the plastic cover oven the air filter
housing and tighten the wing-nut.
IMPORTANT INFORMATION
Do not use compressed air to clean the
paper filter.
4. Pull off the foam plastic pre-filter from the paper
filter and wash clean in mild detergent.
Squeeze it dry in a clean cloth.
Drench it with new engine oil. Wrap the filter in
an absorbent cloth and squeeze out excess oil.
Replace the paper filter if it is clogged with dirt.
3. Remove the wing-nut on the air filter and lift off
the paper filter with pre-filter.

Table of Contents

Other manuals for Husqvarna Rider 16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Husqvarna Rider 16 and is the answer not in the manual?

Husqvarna Rider 16 Specifications

General IconGeneral
Engine ManufacturerBriggs & Stratton
Fuel TypeGasoline
Transmission TypeHydrostatic
DriveRear-Wheel Drive
Deck MaterialSteel

Related product manuals