Hypertherm powermax1000 Service Manual

MAINTENANCE
1
powermax1000 Service Manual 3-33
Align the mark on the strain relief with the mark on the end cap.
4
Pull back the quick-release collar and insert the lead’s gas fitting.
5
Slide the quick-release collar forward to lock in the gas fitting. Verify that the gas fitting is secure.
6
Verify that the red dot on the connector is on top, then plug in the electrical connector. Close the ETR door.
7
Quick-release collar

Hypertherm powermax1000 Specifications

General

Brand	Hypertherm
Model	powermax1000
Category	Welding System
Language	English