9- 12 DO-IT-YOURSELF MAINTENANCE
G120E02A-AAT
Adding Brake Fluid
WARNING:
Handle brake fluid carefully. It can
damage your vision if it gets into
your eyes. Use only DOT 3 or DOT
4 specification fluid from a sealed
container. Do not allow the fluid
can or reservoir to remain open any
longer than required. This will pre-
vent entry of dirt and moisture which
can damage the brake system and
cause improper operation.
!
To add brake fluid, first wipe away any
dirt then unscrew the fluid reservoir
cap. Slowly pour the recommended
fluid into the reservoir. Do not overfill.
Carefully replace the cap on the reser-
voir and tighten.
G130A01A-DAT
CHECKING THE CLUTCH FLUID
To Check the Clutch Fluid
The clutch fluid level in the master
cylinder should be checked when per-
forming other under bonnet services.
The system should be checked for
leakage at the same time.
Check to make certain that the clutch
fluid level is between the "MAX" and
"MIN" level markings on the fluid reser-
voir. Fill as required. Fluid loss indi-
cates a leak in the clutch system which
should be inspected and repaired im-
mediately. Consult your Hyundai dealer.
G130B02A-AAT
To Replace the Fluid
Recommended brake fluid conforming
to DOT 3 or DOT 4 specification should
be used. The reservoir cap must be
fully tightened to avoid contamination
from foreign matter or moisture.
NOTE:
Do not allow any other liquids to
contaminate the brake fluid. Seal
damage will result.
WARNING:
Use caution when handling brake
fluid. It can damage your vision if
you get it in your eyes. It will also
damage your vehicles paint if spilled
on it and not removed immediately.
!
AX6024A-D
To Next Page
Loading...
Need help?
General
