FEATURES OF YOUR VEHICLE 4 - 39
B350A01A-AAT
WINDSHIELD WIPER AND
WASHER SWITCH
The windshield wiper switch has three
positions:
1. Intermittent wiper operation
2. Low-speed operation
3. High-speed operation
NOTE:
To prevent damage to the wiper
system, do not attempt to wipe away
heavy accumulations of snow or
ice. Accumulated snow and ice
should be removed manually. If
there is only a light layer of snow or
B350A01A-D
ice, operate the heater in the de-
frost mode to melt the snow or ice
before using the wipers.
To use the windshield washer, pull the
wiper/washer lever toward the steer-
ing wheel. When the washer lever is
operated, the wipers automatically
make two passes across the wind-
shield. The washer continues to oper-
ate until the lever is released.
B350B01O-GAT
Windshield Washer Operation
B350B01A-D
B340E01A-DAT
Passing Switch
To flash the headlights, pull the switch
lever toward you, then release it. The
headlights can be flashed even though
the headlight switch is in the "OFF"
position.
HLC2071-D
B340D01S-DAT
High-beam and Low-Beam
Switch
To turn on the headlight high beams,
push the lever forward (away from
you). The High Beam Indicator Light
will come on at the same time. For low
beams, pull the lever back toward you.
To Next Page
Loading...
Need help?
General
