Table 74: Load FMR Tape menu (continued)
Function Next menu
Note:
1. Supplemental Message Line 1: Use FMR tape
2. Supplemental Message Line 2:
• Expected FMR tape
• Tape not at load pt
• Tape write prot’d
Cancel
Allows the CE to return to the CE Options menu.
Process Loaded Tape
If an FMR tape is loaded and at ready point, a new menu might display, depending on the previous
menu.
Unload Drive
Allows the CE to unload the cartridge from the drive.
Note: See messages that appear on Supplemental Message Line 2:.
• Expected FMR tape - Scratch tape was loaded.
• Tape not at load pt - Not at ready point, wait for tape cartridge to nish loading.
• Tape write prot’d - If the service panel shows the le-protected icon, the tape cartridge is either
physically write-protected or the customer used a command to logically write-protect the tape
cartridge.
CE Select Level menu
Table 75 on page 116
shows the CE Select menu items. This menu displays when the device loads an
FMR tape (cartridge). The device reads all the EC levels, and displays them on this menu. The invalid EC
levels are displayed in a lighter font. The message lines display the EC level that runs in the device. The
ECs are displayed in the same order as they appear on tape. The CE chooses which EC level to load into
the device.
To activate the drive microcode after you load it, you must complete a power-on reset or a CE reset.
Operational Note: If you insert the FMR cartridge, and the EC level of the microcode is not on the
cartridge, the microcode is copied automatically from the drive to the cartridge.
Table 75:
CE Select Level menu
Function Next menu
Cancel “CE Options menu” on page 107
EC=aaaaaaa LL=bbbb “Status menus” on page 109
EC=ccccccc LL=dddd “Status menus” on page 109
EC=eeeeeee LL=ffff “Status menus” on page 109
Note:
1. Supplemental Message Line 1: Current EC Level:
2. Supplemental Message Line 2: <EC Level q>
116 IBM 3592 TS1140, TS1150, TS1155, and TS1160 Tape Drives: Maintenance Information
To Next Page
Loading...
Need help?
General