Table 22. Voltages (continued)
Pin Voltage Range
Pin 7 Ground
Pin 8 Ground
Pin 9 Ground
Pin 10 Ground
Pin 11 +38 V dc +36.5 / +39.5 V dc
Pin 12 +38 V dc +36.5 / +39.5 V dc
Pin 13 +38 V dc +36.5 / +39.5 V dc
Pin 14 N/A
Pin 15 See note
Notes:
1. Pin 15 is the idle control input signal from the logic board, and will measure0Vdcwhen the power supply is
disconnected from the logic board.
2. When connected to the logic board, pin 15 will be +4.8 to 5.2 V dc at power on, and 0.0 V dc after the printer
is idle for approximately 30 seconds.
Reference Table 9, Base Code Compatibilities
Table 23. Base Code Compatibilities
Base Code For Use With:
twinax no card, serial card, twinax card, LAN card
coax coax card
Chapter 1. Diagnosing Problems
157
To Next Page
Loading...
Need help?
General