Attachment Card Guide Assembly with the Interposer Connector (Model
003)
Removal
Attention: The electronic parts of this printer can be damaged by electrostatic discharge (ESD). Use ESD
protection devices and procedures, including a static discharge wrist strap, while working on the printer.
DANGER
To prevent serious personal injury from electrical shock when connecting or disconnecting the interface
cable, set the printer power switch to O (Off) and unplug the power cord.
DANGER
Do not connect or disconnect any communication port, teleport, attachment connector, or power cord
during an electrical storm.
1. Power off (O) the printer and unplug the power cord from the printer.
2. Remove the Attachment Card. See “Model 003 Attachment Cards: Serial, Twinax, LAN, Coax” on page 359.
3. Put the rear cover in the service position. See “Removing Covers” on page 275.
4. Remove 3–M3x6 and 1–M3x8 screws securing the Attachment Card Guide Assembly (ACGA) to the printer
base and support posts, and remove 1–M3x4 screw securing the grounding strap to the frame, using a long
shaft magnetic P1 Phillips tip screwdriver.
Chapter 5. Removals and Adjustments 364
To Next Page
Loading...
Need help?
General