NOTE
The paper bail may be slightly different than the ones shown here. Later models may have a coil spring.
3. Check the forms guide metal deflector setting.
The forms guide has a metal forms guide deflector that has two positions. The closed (up) position is used
for rear tractor pull configurations. The open (down) position is used for front or rear tractor push, manual
sheet feed, and ASF configurations.
Ensure that the metal forms guide deflector is in the correct position for the paper path configuration being
used.
hc0z0002
Figure 56. Correct Installed Position for Paper Bail.
Chapter 5. Removals and Adjustments 302
To Next Page
Need help?
General