Table 18. Interpreting the results of the self-test (continued)
Result Description
Incorrect cartridge When an incorrect tape cartridge is used for the test, the cartridge is unloaded and both the
Activity and Clean LEDs will flash. This can happen if the cartridge is:
v Write-protected
v Damaged
v Not write-compatible with the drive
Press the eject button to end the self-test and return the drive to normal operating mode.
Then return to step 1 and run the self-test again using a suitable cartridge.
Returning to normal operation
When self-testing has completed successfully, the tape cartridge is unloaded. The drive is no longer in
diagnostic mode and returns to normal operation.
When self-testing fails, the tape cartridge remains loaded inside the drive, and the drive remains in
diagnostic mode. Press the eject button to unload tape cartridge and return drive to normal operation.
160/320 GB internal tape drive VXA-320 (FC 6279)
Learn about the features of this media device.
Table 19. 160/320 GB internal tape drive VXA-320 features
Features Description
Description The IBM 160/320 GB Internal Tape Drive with VXA Technology is a 5.25-inch, half-high,
Ultra2 LVD 16-bit tape drive, which provides a high capacity for save/restore and achieve
functions. This tape drive uses VXA tape data cartridges and is capable of compression,
providing a capacity of up to 320 GB.
Characteristics:
v FRU part number: 95P1976
v Custom card identification number (CCIN): 63A0
v Capacity: 160 GB native mode, 320 GB (typical) compression mode
v Form Factor: 5.25-inch half high
v Media: uses VXA tape data cartridges
v Technology: Helical scan, rotating head
v Operation: Streaming
v Data Transfer Rate: 12 MBps native mode, 24 MBps (typical) compression
v Interface: SCSI-2 (LVD/SE) asynchronous/synchronous
v Compatibility: 160 GB mode (Read/Write), 320 GB compression (Read/Write)
v Attributes provided: One 160/320 GB internal tape drive
v Attributes required: One 1.6-inch (41 mm) half-high media bay and one SCSI-2 internal
16-bit address
Tools The following tools and documentation are needed to complete the installation:
v A flat-blade screwdriver (if this device is not an auto-docking feature on your system)
v Your system unit documentation, including any service documentation
v Your operating system documentation
If an item is missing or damaged, contact the place of purchase.
26 Managing devices
To Next Page
Loading...
Need help?
General