2. Calculate the total area that is needed for model configuration by adding the
weight distribution area to the dimensions determined from Table 52 on page
149.
3. Determine the total space that is needed for the storage units by planning the
placement of each model configuration in the storage units and how much area
each configuration requires based on step 2.
Note: You must provide two Ethernet cables that are straight four pair UTP
CAT5e Ethernet cable with RJ-45 jacks. They must be a minimum of 100
meters (330 feet) long. One Ethernet cable must be labeled "Black" on
both ends. The other cable must be labeled "Gray" on both ends. All
private network cables are marked as "Black" or "Gray" to visually
distinguish the redundant network cabling.
4. Verify that the planned space and layout also meets the service clearance
requirements for each unit and system.
Dimensions and weight of individual models
When you are planning the floor and space requirements for your storage units,
consider the dimensions and weights of the models that compose your storage
units.
Table 53 provides the dimensions and weights of the DS8000 models.
Table 53. DS8000 dimensions and weights
Model Dimensions (see Note 1) Maximum weight
of fully configured
base models and
expansion models
(see Notes 2 and 3)
Maximum
weight of second
expansion
models (see
Notes 2 and 4)
Model 941
Height 193 cm (76 in.)
Width 84.7 cm (33.35 in.)
Depth 118.3 (46.6 in.)
1209 kg
(2640 lb)
(Not
applicable)
Model 94E
Height 193 cm (76 in.)
Width 84.7 cm (33.35 in.)
Depth 118.3 (46.6 in.)
1109 kg
(2420 lb)
887 kb
(1930 lb)
Model 951
Height 193.4 cm (76 in.)
Width 84.8 cm (33.4 in.)
Depth 122.7 (48.3 in.)
1216 kg
(2675 lb)
N/A
Model 95E
Height 193.4 cm (76 in.)
Width 84.8 cm (33.4 in.)
Depth 122.7 (48.3 in.)
1157 kg
(2545 lb)
1068 kg
(2355 lb)
Chapter 6. Meeting DS8000 series delivery and installation requirements 151
To Next Page
Loading...
Need help?
General