14. Follow the instructions on the screen to install the adapter until the LED for the
specified PCI slot is set to the Action state. See “Model D20 PCI-X Slots” on
page 16.
15. When you are instructed to install the adapter in the adapter slot, carefully grasp
the adapter by the edges and align the adapter in the slot guides. Insert the
adapter fully into the adapter slot connector. If you are installing a full-length
adapter, ensure that both ends of the adapter engage the card guides.
16. Lower the adapter retaining seat onto the PCI adapter face plate. Rotate the
adapter retainer clip until it stops.
17. Close then secure the service access cover with the three thumbscrews located on
its back edge.
18. Connect the adapter cables.
19. Route the adapter cables through the cable-management arm.
20. Push the system drawer back into the operating position as described in “D20
Operating Position” on page 126.
21. Close the rack doors.
Chapter 8. Removal and Replacement Procedures 159
To Next Page
Loading...
Need help?
General