D10 Covers
Before performing the following procedure, read the “Safety Considerations” on
page 53.
Service Access Cover Removal
To remove the service access cover, do the following:
1. Perform the procedure to put the I/O subsystem into the service position as
described in “D10 Service Position” on page 57.
2. Loosen the two captive thumbscrews located on the rear of the cover.
3. From the rear of the I/O subsystem, lift the cover and slide it backwards until the
front disengages. Lift the cover off the I/O subsystem drawer.
1
2
1 Service access cover 2 Thumbscrews
Chapter 8. Removal and Replacement Procedures
59
To Next Page
Loading...
Need help?
General