4. Select the appropriate power-off mode and click OK.
Related information:
Shutting down and restarting logical partitions
Stopping a system by using the HMC Enhanced + Tech Preview (Pre-GA) or HMC
Enhanced+ interface
Learn how to stop a system by using the HMC Enhanced + Tech Preview (Pre-GA) or HMC Enhanced+
interface.
To stop the system or logical partition by using the HMC Enhanced + Tech Preview (Pre-GA) or HMC
Enhanced+ interface, complete the following steps:
1. You must deactivate all the active logical partitions before powering off the system. To deactivate
logical partitions for a specific system, complete the following steps:
a. In the navigation area, click the Resources icon , and then click All Systems.
b. Click the system name for which you want to deactivate partitions.
c. Select the logical partitions that you want to deactivate.
d. In the content pane, click Actions > Deactivate.
e. Click OK.
2. To power off the system, complete the following steps:
a. In the navigation area, click the Resources icon , and then click All Systems.
b. Select the system that you want to power off.
c. In the content pane, click Actions > View All Actions > Power Off.
d. Click OK.
Stopping an IBM PowerKVM system
You can use the Intelligent Platform Management Interface (IPMI) to stop an IBM PowerKVM system.
To stop an IBM PowerKVM system, complete the following steps:
1. Log in to the host as a root user or with sudo authority.
2. To power off each of the guests, complete the following steps.
a. To obtain a list of all guests, type virsh list.
b. For each guest in the list, type virsh shutdown domain name or type virsh shutdown domain ID.
Note:
Type virsh list to verify whether all the guests are powered off. If any guest is not powered off,
type virsh destroy domain name or type virsh destroy domain ID to power off the guest.
3. Run the ipmitool -I lanplus -H FSP IP -P ipmipassword chassis power off command from a remote
system.
Starting the system or logical partition
Learn how to start a system or logical partition after performing a service action or system upgrade.
136 Disk drives or solid-state drives
To Next Page
Loading...
Need help?
General