Figure 44. Installing the service access cover
3. Push the system unit (B) back into the rack until both release latches of the system unit lock into
position.
Secure the cable management arm with hook-and-loop fasteners around the back side of the cable
management arm, but not around the cables.
4. Using your labels, reconnect the power cords (A) to the system unit.
Fasten the power cords to the system using the hook-and-loop fasteners (B) as shown in Figure 45 on
page 46.
Drive backplanes for the 5105-22E, 9008-22L, 9009-22A, 9009-22G, or 9223-22H
45
To Next Page
Loading...
Need help?
General