IBM Storwize V7000 User Manual

Create cluster command
Use this command to create a storage system.
Syntax
 satask mkcluster -clusterip ipv4
-gw ipv4 -mask ipv4 -name cluster_name

 satask mkcluster -clusterip_6 ipv6
-gw_6 ipv6 -prefix_6 int -name cluster_name

Parameters
-clusterip
(Optional) The IPv4 address for Ethernet port 1 on the system.
-gw
(Optional) The IPv4 gateway for Ethernet port 1 on the system.
-mask
(Optional) The IPv4 subnet for Ethernet port 1 on the system.
-clusterip_6
(Optional) The IPv6 address for Ethernet port 1 on the system.
-gw_6
(Optional) The IPv6 gateway for Ethernet port 1 on the system.
-prefix_6
(Optional) The IPv6 prefix for Ethernet port 1 on the system.
-name
(Optional) The name of the new system.
Description
This command creates a storage system.
This command calls the satask mkcluster command.
Query status command
Use this command to determine the current service state of the node canister.
Syntax
 sainfo getstatus 
Parameters
None.
Description
This command writes the output from each node canister to the USB flash drive.
This command calls the sainfo lsservicenodes command, the sainfo
lsservicestatus command, and the sainfo lsservicerecommendation command.
Chapter 5. Storwize V7000 user interfaces for servicing your system 41

IBM Storwize V7000 Specifications

General

Brand	IBM
Model	Storwize V7000
Category	Storage
Language	English