Replacing the air baffle
To replace the air baffle (if it has been removed), complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 38.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables (see “Turning off the server” on page 28).
3. Align the air baffle pins with the baffle pin holes on both sides of the chassis;
then, lower the air baffle into the server. Press the air baffle down until it is
securely seated.
Note: Close the retaining clip on each end of the DIMM connector before
installing the air baffle for proper cooling.
Replacing the cover
To replace the server cover, complete the following steps:
1. Make sure that all cables, adapters, and other components are installed and
seated correctly and that you have not left loose tools or parts inside the server.
Also, make sure that all internal cables are correctly routed.
Important: Before you slide the cover forward, make sure that all the tabs on
the front, rear, and side of the cover engage the chassis correctly. If
all the tabs do not engage the chassis correctly, it will be very
difficult to remove the cover later.
2. Position the cover on top of the server.
3. Slide the cover toward the front of the server.
4. Make sure that the cover correctly engages all the inset tabs on the server.
5. Press down the blue latch on the top (in the center of the front of the server) of
the cover.
102 IBM System x3550 M4 Type 7914: Installation and User’s Guide
To Next Page
Loading...
Need help?
General