1. Read the safety information that begins on page vii and “Installation guidelines”
on page 38.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
Note: When you disconnect the power source from the server, you lose the
ability to view the LEDs because the LEDs are not lit when the power
source is removed. Before you disconnect the power source, make a
note of which LEDs are lit, including the LEDs that are lit on the
operation information panel, on the light path diagnostics panel, and
LEDs inside the server on the system board; then, see the Problem
Determination and Service Guide for information about how to solve the
problem.
3. If the server has been installed in a rack, slide the server out from the rack
enclosure.
4. Pull up firmly on the blue latch on the top (in the center of the front of the
server) of the cover and slide the cover toward the rear of the server until the
cover has disengaged from the chassis.
5. Lift the server cover off the server and set it aside.
Attention: For proper cooling and airflow, replace the server cover before you
turn on the server.
Removing the air baffle
To remove the air baffle, complete the following steps:
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 38.
2. Turn off the server and peripheral devices and disconnect the power cords and
all external cables, if necessary.
3. Remove the cover (see “Removing the cover” on page 50).
4. Grasp the air baffle, disengage pins from pin holes; then, lift the air baffle up.
Chapter 2. Installing optional devices 51
To Next Page
Loading...
Need help?
General