6
Mixed Digital Repeating
A repeater set for mixed digital is capable of receiving both digital and analog signals, and will transmit in the
format received. The front hand mic transmissions will be digital.
Program your radio with the following settings. All frequencies need to be entered and the squelch level must
be set before programming the following settings.
Common Window
>
Set to Enable. When enabled, the Digital window appears.
Memory CH Window
Multiple Table Window
Table No.
Set to desired number. Can have as many as 16 tables. If you
have created more than 1 table, entering a number in this field
will bring up the matching table.
Set to Analog or Digital.
Set to the desired CTCSS tone or RAN code set. Note: RAN
codes are decimal.
Enter RX and TX frequencies.
Enter appropriate text for the channel name.
RF PWR Set the desired power level. Choices are L1 (5W), L2 (25W),
Set to Mixed-Digi. This allows receiving in analog and digital
and transmitting the same format as was received.
>
Set to ON (the CW window contains the timers and ID).
TX C Tone If the Multiple Table is not enabled, tones apply to TX only; RX
is open squelch. The front hand mic uses this TX tone.
If RX and TX tones are required, use the Multi Table to set the
Set to the desired number. It points to the tone/RAN settings in
the Multiple Table screen. The repeater will RX and TX for the
assigned channel using the tones/RAN’s referenced in this
window. Note: if there is no value entered, the radio will RX on
any tone and transmit on the tone entered in the TX C Tone or,
if set to Digital, will have no RAN for TX and RX.
TX RAN
Front mic functionality only. Repeater will TX this RAN from the
front mic.
To Next Page
Loading...
Need help?
General
