EasyManuals Logo
Home>Icom>Transceiver>IC-2300H

Icom IC-2300H Service Manual Addendum

Icom IC-2300H
41 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
This service manual describes the latest technical
information for the IC-2300H FM TRANSCEIVER, at the
time of publication.
NEVER connect the transceiver to an AC outlet or to a DC
power supply that uses more than the specified voltage.
This will ruin the transceiver.
DO NOT expose the transceiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the transceiver.
DO NOT apply an RF signal of more than 20 dBm
(100 mW) to the antenna connector. This could damage the
transceiver’s front-end.
To upgrade quality, any electrical or mechanical parts
and internal circuits are subject to change without notice
or obligation.
MODEL VERSION
TX
POWER
IC-2300H
TPE 24 W
USA 65 W
KOR 50 W
EXP-01
65 W
EXP-02
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom part number
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
1110003491 S.IC TA31136FNG IC-2300H MAIN UNIT 5 pieces
8820001210 Screw 2438 screw IC-2300H Top cover 10 pieces
Addresses are provided on the inside back cover for your
convenience.
ORDERING PARTS
1. Make sure that the problem is internal before dis-
assembling the transceiver.
2. DO NOT open the transceiver until the transceiver is
disconnected from its power source.
3. DO NOT force any of the variable components. Turn them
slowly and smoothly.
4. DO NOT short any circuits or electronic parts. An
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
transceiver is defective.
6. DO NOT transmit power into a Standard Signal Generator
or a Sweep Generator.
7. ALWAYS connect a 40 to 60 dB attenuator between the
transceiver and a Deviation Meter or Spectrum Analyzer,
when using such test equipment.
8. READ the instructions of the test equipment throughly
before connecting it to the transceiver.
REPAIR NOTES
INTRODUCTION CAUTION
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia and/or other countries.

Other manuals for Icom IC-2300H

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Icom IC-2300H and is the answer not in the manual?

Icom IC-2300H Specifications

General IconGeneral
Radio typePortable
Supported radio bandsFM
RMS rated power65 W
Display typeLCD
Backlight colorAmber/Yellow/Green
Built-in displayYes
Headphone connectivity3.5 mm
Product colorBlack
Power sourceDC
Operating temperature (T-T)-10 - 60 °C
Weight and Dimensions IconWeight and Dimensions
Depth162 mm
Width140 mm
Height40 mm
Weight1100 g

Related product manuals