Icom IC-F9511T User Manual

✔ For
Trunking mode operation:
Receiving
APCO P25 Mode Operation
This function is available only for a dispatcher in the
Trunking mode.
1Push [Digital Button] to enter the digital call
type selection mode.
2Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select “RDO CHECK.”
➥ When a radio check signal is received, the
transceiver automatically transmits an
acknowledgement.
• The Busy indicator lights green while
receiving, and lights red while transmitting an
acknowledgement.
• The function display does not change while
transmittin
g
.
3Push [Digital Button] again to enter the Individual
ID selection mode.
• A pre-programmed ID name is displayed.
• When the ID name is not programmed
g
■ Status Message
Transmitting
The transceiver can send one of up to 100 different
pre-programmed Status Messages.
[Digital Button] or [Digital Status] key assignment is
necessary to transmit the Status Message
• When the ID name is not programmed
,
the ID code is displayed.
4Push [CH Up] or [CH Down], or rotate
[CH U /D ]
t l t th d i d ID ( )
necessary to transmit the Status Message
.
✔ For Trunking mode operation:
The Status Message can be sent only to a dispatcher
in the Trunking mode.
1Push [Digital Button] to enter the digital call type
selection mode.

[CH U
p
/D
own
]
t
o
se
l
ec
t th
e
d
es
i
re
d ID (
or
name
)
.
• Push and hold [Digital Button] for 1 sec to
cancel and return to normal operation.
• The ID can be edited with the 10-keypad*.
(Depending on the pre-set value.)
*10-key models only.
5Push [PTT] to transmit the radio check signal to
the target station

✔ Quick access
 Push [Digital Status] to directly enter the Status
 Message selection mode. In this case, skip steps
 2 and 3. Go to step 4.
2Push [CH Up] or [CH Down], or rotate [CH
Up/Down] to select “STATUS.”
the target station
.
• The Transmit indicator lights red.
• “PLEASE WAIT” is displayed.
6Release [PTT].
• “ACK RECEIVED” is displayed after receiving an
acknowledgement from the target station, and
then the transceiver returns to normal operation.
• Bus
y
indicator li
g
hts
g
reen.
3Push [Digital Button] again to enter the Status
Message selection mode.
• A pre-programmed Status Message is displayed.
ygg
• “NO ACKNOWLDG” is displayed when an
acknowledgement is not received and the
transceiver returns to normal operation.
4Push [CH Up] or [CH Down], or rotate
[CH Up/Down] to select the desired Message.
 While in the Trunking mode, the following steps

5
and
6
are not necessary Go to step
7
50

5
and
6
are not necessary
.
Go to step
7
.

Icom IC-F9511T Specifications

General

Brand	Icom
Model	IC-F9511T
Category	Transceiver
Language	English