Icom IC-R2 User Manual

12
5
MEMORY CHANNELS
■ General
The receiver has 400 memory channels in 8 banks for stor-
age of often-used frequencies.
D Memory channel contents
The following information can be programmed into memory
channels:
•Operating frequency (p. 7)
•Receive mode (p. 11)
•Tuning step (p. 7)
•Duplex direction (DUP or –DUP) with an offset frequency
(p. 24)
•Tone squelch ON/OFF (p. 22)
•Tone squelch frequency (p. 22)
•Scan skip setting (p. 18)
■ Programming during selection
q Select VFO mode with [V/M].
w Set the desired frequency:
➥ Select the desired band with [BAND].
➥ Set the frequency using [DIAL].
➥Set other data (e.g. offset frequency, duplex direction,
tone squelch frequency, etc.), if required.
e Push [FUNC] + [
(V/M)MW] momentarily to indicate memory
channels.
•Do not hold [FUNC] + [(V/M)MW] for more than 0.5 sec., other-
wise the previously selected memory channel will be overwritten.
r Rotate [DIAL] to select the desired channel.
•VFO (VF), as well as regular memory channels, can be pro-
grammed in this way.
•Rotate [DIAL] while pushing [FUNC] to select a memory bank,
programmed scan edge channel or VFO.
t Push [FUNC] + [(V/M)MW] for 1 sec. to program.
•Keep pushing for 2 sec. or more to automatically select the next
memory channel, if desired.
FM DUPTSQL FM DUPTSQLFM
MR MR
1
momentarily
blank channel
for 2 sec.
+
FUNC
+
FUNC
for bank
selection
for CH
selection
+
FUNC
V/M MW V/M MW
[EXAMPLE]: Programming ch 40 of memory bank 5 during selection.

Icom IC-R2 Specifications

General

Brand	Icom
Model	IC-R2
Category	Receiver
Language	English