This service manual describes the latest technical
information for the IC-R6 COMMUNICATIONS RECEIVER,
at the time of publication.
NEVER connect the receiver to an AC outlet or to a DC
power supply that uses more than specified. This will ruin
the transceiver.
DO NOT expose the receiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the receiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector. This could damage the receiver’s
front-end.
To upgrade quality, any electrical or mechanical parts
and internal circuits are subject to change without notice
or obligation.
MODEL VERSION
SUPPLIED
BATTERY CHARGER
IC-R6
EUR
–
UK
CHN
ITA
USA
FRA
ESP
EXP
CAN
EUR-01 BC-196SD
CHN-01 BC-153SC
ITA-01 BC-196SD
USA-01 BC-196SA
FRA-01
BC-196SD
ESP-01
CAN-01 BC-196SA
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom part number
2. Component name
3. Equipment model name and unit name
4. Quantity required
<ORDER EXAMPLE>
1110007300
NJM2552V
IC-R6 RF UNIT 2 pieces
8210026030 3250 REAR PANEL
IC-R6 CHASSIS 3 pieces
Addresses are provided on the inside back cover for your
convenience.
ORDERING PARTS
1. Make sure that the problem is internal before
disassembling the receiver.
2. DO NOT open the receiver until the receiver is
disconnected from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts. An
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
receiver is defective.
6. READ the instructions of test equipment throughly
before connecting a test equipment to the receiver.
REPAIR NOTES
INTRODUCTION
CAUTION
Icom, Icom Inc. and the Icom logo are registered trademarks of Icom Incorporated (Japan) in Japan, the United States, the
United Kingdom, Germany, France, Spain, Russia and/or other countries.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
