17
4
BASIC OPERATION
D By other methods
Via the [
YY
]/[
ZZ
] keys
Each push increases/decreases the frequency by the selected tun-
ing step
.
Using the [VOL]
Rotate the [VOL] to increase/decrease the frequency with the se-
lected tuning step.
• This function is available when “dial” is assigned with [VOL] in
INITIAL
SET MODE
(p. 50).
✔ For your information
Tuning steps:
The transceiver has 8 tuning steps as follows:
5 kHz 10 kHz 12.5 kHz 15 kHz
20 kHz 25 kHz 30 kHz 50 kHz
• A tuning step is selected in
SET MODE
. (p. 46)
■ Setting audio/squelch level
D To set the audio level
Rotate the [VOL] to set the desired audio level while receiving
the signal.
• When no signal is received, push and hold [SQL] while setting the
audio level.
• When [VOL] is assigned as “dial,” push [Y]/[Z] to adjust the audio
output level. (p. 50)
D To set the squelch level
While pushing [SQL], push [Y]/[Z] to set the squelch level.
• The squelch level “1” is loose squelch, “10” is tight squelch.
• When [VOL] is assigned as “dial,” rotate [VOL] while [SQL] is
pushed. (p. 50)
IC-T3H.qxd 03.2.6 10:18 Page 17 (1,1)
To Next Page
Loading...
Need help?
General
