22
5
REPEATER OPERATION
■ Offset frequency
When communicating through a repeater, the transmit frequency is
shifted from the receive frequency by an amount determined by the
offset frequency.
q Push [A•
FUNC
], then push [8•
SET
] to enter
SET MODE
.
w Push [Y]/[Z] several times until “±” and
offset frequency appear.
e Rotate [VOL] to select the desired offset
frequency.
• Selectable steps are the same as the pre-set tuning steps.
• The unit of the displayed offset frequency is “MHz.”
r Push [#•
ENT
] to fix the offset frequency and exit
SET MODE
.
■ Subaudible tones
Some repeaters require subaudible tones to be accessed. Sub-
audible tones are superimposed over your normal signal and must
be set in advance.
q Push [A•
FUNC
], then push [8•
SET
] to enter
SET MODE
.
w Push [Y]/[Z] one or more times until “rt”
appears.
e Rotate [VOL] to select the desired subaudible tone.
r Push [#•
ENT
] to enter the selected tone and exit set mode.
Available subaudible tone frequencies (unit: Hz)
USING
SET MODE
USING
SET MODE
To Next Page
Loading...
Need help?
General
