25
6
MEMORY PROGRAMMING
■ Channel name programming
q Select a “Channel Name Indication” type in
INITIAL SET MODE
(p. 50).
w Push [C•
MR
] to select memory mode, if necessary.
e Push [A•
FUNC
], then push [8•
SET
] to enter into the channel name
programming mode.
• The character to be edited flashes.
r Rotate [VOL] to select a character.
t Push [Y] to move to the right, [Z] to move to the left.
• Up to 5 characters can be used for channel name.
• Usable characters are; A–Z, 0–9, ”space“, +, –, =, ✱, /, [, and ]
y Push [#•
ENT
] to fix and exit the channel name programming
mode.
■ Memory transferring
Memory (call) channel contents can be transferred to the VFO or
to another memory channel.
D Memory/call ➾ VFO
q Select the memory (call) channel to be transferred:
Push [C•
MR
] ([
B•
CALL
]) to select memory (call) mode.
Push [Y]/[Z] to select the memory channel.
• When [VOL] is assigned as “dial,” rotate [VOL] to select the mem-
ory channel. (p. 50)
w Push [A•
FUNC
], then push [C•
MR
] for 1 sec. to transfer the se-
lected memory contents to the VFO.
• VFO mode is selected automatically.
IC-T3H.qxd 03.2.6 10:18 Page 25 (1,1)
To Next Page
Loading...
