38
9
10
10
SET MODES
■ Set mode programming
The Set mode is used to change the settings of the trans-
ceiver’s functions.
D Set mode operation
q
Push [FUNC](M), and then [SET](8) to enter the Set mode.
w Push [] or [] to select the desired item.
e Rotate [VOL] to select the option or value.
r To exit the Set mode, push [# ENT].
• Repeater tone
frequency (p. 39)
• Tone squelch
frequency (p. 39)
• DTCS code (p. 39) • DTCS polarity (p. 39) •
Frequency offset (p. 40)
•
Reverse
duplex
functon
(p. 40)
• Tuning step (p. 40)
•
Scan resume setting (p. 40)
•
Function key timer (p. 40)
• LCD backlight (p. 41)• TX permission (p. 41)• VOX gain (p. 41)
• Microphone gain (p. 41)
• Weather alert* (p. 41)
• VOX delay (p. 41)
• VOX time-out timer (p. 42)
• DTMF TX key (p. 42)
• Operating mode (p. 42)
*Appears for only the U.S.A.
version transceivers.
: Push
: Push
NOTE: When the display type setting (pp. 27, 46) is set
to “CH” in the Initial Set mode, and accessing the Set
mode from the memory mode, most of Set mode items
do not appear.
To Next Page
Loading...
Need help?
General
