2
1
■ Battery pack/case
To attach the battery pack/case:
q Fit the battery pack/case in the direction of the arrow (q),
then close.
w Hook the latch until it makes a ‘click’ sound (w).
To remove the battery pack/case:
Be careful! The latch is tightly locked, so use caution
when releasing it. DO NOT use your finger nail. Use the
edge of a coin or screwdriver tip to carefully release it.
➥ Unhook the latch (e), and lift up the battery pack/case in
the direction of the arrow (r).
NEVER remove or attach the battery pack/case when the
transceiver is wet or soiled. This may result in water or
dust getting into the transceiver/battery pack/case, and
may result in them being damaged.
NOTE: Keep the battery terminals clean. It’s a good idea
to clean the battery terminals once a week.
■ Jack cover
Attach the jack cover when optional equipment is not used.
1
ACCESSORIES
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
To attach the jack cover
q Attach the jack cover to
the [SP MIC] jack.
w Tighten the screws.
To detach the jack cover
e Remove the screws with a
phillips screwdriver.
r Detach the jack cover to
connect optional equip-
ment.
To Next Page
Loading...
Need help?
General
