9
2 VOICE SCRAMBLER
D Scrambler setting
q Push [SET(LOCK)] to enter set mode.
w Push [SET(LOCK)] or [MW(S.MW)] several times until
“SCG” appears.
• When the UT-109 is installed, skip steps w and e. Continue
from step r.
e Rotate the tuning dial to select the desired group code
from 1–4.
• The same group code must be selected in your group.
r Push [SET(LOCK)] or [MW(S.MW)] several times until
“SCR” appears.
t Rotate the tuning dial to select the desired scramble code.
• Select a scramble code from 0–20 (32 codes; hexadecimal digit)
when UT-109, 0–FF (256 codes) when UT-110 is installed.
y Push [TONE(T-SCAN)] to exit set mode.
‘‘
Operation
q Set the desired operating frequency.
• Set other conditions, such as repeater, tone squelch, etc.
w Push [BANK(OPT)] for 1 sec. to turn the voice scrambler
function ON.
•“ ” appears.
e Operate the transceiver in the normal way (push [PTT] to
transmit; release [PTT] to receive).
r To turn the voice scrambler function OFF, push
[BANK(OPT)] for 1 sec. again
•“ ” disappears.
To Next Page
Loading...
Need help?
General
