2
1
ANI FUNCTION
‘‘
Preparation
q Push [BANK(OPT)] for 1 sec. to select the pager mode.
• Repeat several times if necessary.
• 100 MHz digit shows “P.”
w Program your ID and the station codes.
• Set your ID into channel C0 and station codes into C1 to C6.
➥ Push [SET(LOCK)].
➥ Rotate the tuning dial to select the code channel.
➥ Push [MW(S.MW)] then rotate the tuning dial to set the 1st
digit of a code. Repeat this step 2 more times to input 3-digit
code, then push [MW(S.MW)].
➥ Push [TONE(T-SCAN)] to return to step q condition.
e
Set the operating frequency, code channel and other condi-
tions, such as tone squelch, tone frequency, etc., if desired.
•
When entering set mode to select tone frequency or DTCS code,
you must deactivate the pager mode.
➥ Push [SET(LOCK)].
➥ Push [SET(LOCK)] or [MW(S.MW)] several times to select the
desired item.
➥ Rotate the tuning dial to select a tone frequency or DTCS
code and polarity.
➥ Push [TONE(T-SCAN)] to return to the previous indication.
r Push [MW(S.MW)] for 1 sec. to program the contents into
the desired memory channel.
•
Memory bank can also be selected, if desired.
t Repeat steps e and r to program other settings.
y Select channel number indication mode.
➥ Turn the power OFF.
➥ While pushing [SET(LOCK)] turn the power ON.
➥ Push [SET(LOCK)] or [MW(S.MW)] several times until “DSP”
appears.
➥ Rotate the tuning dial to select “DSP--CH.”
u Turn the ANI mode ON.
➥ Push [SET(LOCK)] or [MW(S.MW)] several times until “ANI”
appears.
➥ Rotate the tuning dial to select “ANI--ON.”
i Push [PWR] to exit initial set mode.
• ANI mode is selected— “A” is displayed as below.
To Next Page
Loading...
Need help?
General
