[#] [USER CODE]
(Do not leave premises)
1. Select the required STAY PROFILE (See page 19)
2. Ensure that the READY indicator is on. If not, check that all protected doors and windows are
closed and that all movement has ceased in the areas covered by motion detectors.
3. Press the [#] key.
4. Enter a valid [USER CODE]. If an incorrect code is entered, the keypad will give an error beep. In
the event of an error press the [#] key and re-enter the [USER CODE].
5. The ARMED indicator will come on and the keypad buzzer will sound for the duration of the exit
delay.
6. DO NOT violate the Entry/Exit zone (normally the front door). If the Entry/Exit zone is violated the
system will arm in the AWAY mode.
7. Upon expiry of the exit delay, the AWAY indicator will remain off.
8. Any STAY zones will be automatically bypassed (indicated by a steadily on indicator).
9. Ensure that you enter only those areas that are bypassed.
6.4
6.4 6.4
6.4
Quick Stay Arm
Quick Stay ArmQuick Stay Arm
Quick Stay Arm
Hold down the [5] key until the beep
It is possible to STAY arm by holding down the [5] key until the keypad buzzer sounds. The panel will
immediately arm into the stay mode without any exit delay. All stay zones will be bypassed.
N
NN
NOTE
OTEOTE
OTE:
::
:
Holding the button down again will cause the panel to toggle between stay profiles. This STAY profile
then becomes the active profile and the panel will STAY arm using this profile - until you elect to switch
profiles again.
6.4.1
6.4.1 6.4.1
6.4.1
How to Stay Arm
How to Stay ArmHow to Stay Arm
How to Stay Arm and Go
and Go and Go
and Go
Hold down the [6] key until the beep
This is a single key arm function that allows the user to STAY arm and leave the premises. If a partition is
already stay armed, holding down the [6] key initiates an exit delay, thus allowing the user to leave the
premises without disarming. At the end of the exit delay, the partition will re-arm in the same stay profile it
was armed in before the [6] key was held down.
1. Hold down the [6] key until the keypad buzzer sounds. The keypad buzzer will sound for the
duration of the exit delay. Only leave via a designated exit route.
2. At the end of the exit delay, the ARMED indicator will come on and the AWAY indicator will remain
off. All stay zones will be bypassed.
NOTE
NOTENOTE
NOTE:
: :
:
Holding down the [6] key until the keypad buzzer sounds also ensures an entry delay on entering the
premises.
To Next Page
Loading...
Need help?
General
