IDS 816 User Manual

IDS816 User Manual 700-283-01H Issued January 2009
17
5. Enter the [NEW CODE] followed by the [*] key.
6. The READY and ARMED indicators will flash simultaneously.
7. To edit other codes repeat steps 3 to 5.
8. Press the [#] key to exit the User Program Mode.
13.4
13.4 13.4
13.4 View a
View a View a
View a User
UserUser
User C
C C
Code
odeode
ode Slot Number
Slot Number Slot Number
Slot Number –
––
– Option 3
Option 3 Option 3
Option 3
Hold down the [*] key until the beep,
then enter [MASTER CODE] [*] [3] [*] [USER CODE] [*]
1. Enter the User Program Mode as per steps 1 to 4 on page 14.
2. Press the [3] key followed by the [*] key to select programmable option 3. The READY and
ARMED indicators will flash simultaneously.
3. Enter the [USER CODE] followed by the [*] key.
4. The READY indicator will flash and the AWAY indicator will be on.
5. The [USER CODE] slot number will be displayed by the Zone indicators. (See table 2)
6. Press the [#] key to exit the User Program Mode.
13.5
13.5 13.5
13.5 User
UserUser
User C
C C
Code
odeode
ode Properties
Properties Properties
Properties –
––
– Option 4
Option 4 Option 4
Option 4
Hold down the [*] key until the beep,
then enter [MASTER CODE] [*] [4] [*] [USER CODE] [*] [PROPERTY No.] [*]
1. Enter the User Program Mode as per steps 1 to 4 on page 14.
2. Press the [4] key followed by the [*] key to select programmable option 4. The READY and
ARMED indicators will flash simultaneously.
3. Enter the [USER CODE] followed by the [*] key.
4. The READY indicator will flash and the AWAY indicator will be on.
5. The properties assigned to the user code are displayed by the Zone indicators. LED(s) that are on
indicate that certain properties have been assigned to the user code. Refer to Table 2 for a list of
user code properties.
6. To select a user code property, press the key which corresponds to that property followed by the
[*] key. The appropriate zone LED will come on. To deselect a property, press the corresponding
key followed by the [*] key and the LED will be turned off.
Example:
To enable a user code to function as a duress code press the [2] key followed by the [*] key. The
zone 2 LED will come on to confirm the selection.
7. Repeat step 6 until the desired properties have been programmed.
8. Press the [#]
[#][#]
[#] key to exit the User Program Mode.

IDS 816 Specifications

General

Brand	IDS
Model	816
Category	Keypad
Language	English