IDS 816 User Manual

IDS816 User Manual 700-283-01H Issued January 2009
13
8.
8. 8.
8. Bypassing Zones
Bypassing ZonesBypassing Zones
Bypassing Zones
 The term BYPASS is used to describe a zone that has been deactivated; i.e. violation of a
bypassed zone is ignored and will not cause an alarm condition.
 Once the system is armed, it is not possible to bypass zones.
 All bypassed zones will be automatically cancelled each time the panel is disarmed and must be
re-bypassed before the next arming.
8.1
8.1 8.1
8.1 Bypass
BypassBypass
Bypassing
inging
ing/Un
/Un/Un
/Un-
--
-b
bb
bypass
ypassypass
ypassing
inging
ing a Zone
a Zonea Zone
a Zone
Hold down [9] key until the beep,
then enter [ZONE NUMBER] [*] [#]
1. Ensure that the panel is not armed (Armed LED OFF).
2. To enter bypass mode, hold down the [9] key for one second (until the keypad buzzer sounds).
The Away LED will flash, and bypassed zones will be indicated by zone LED’s that are on.
3. Entering a zone number [ZONE NUMBER] [*] will toggle the corresponding LED. For example,
[2] [*] will turn LED 2 on (if it was off) and off (if it was on).
4. Turn on the LED’s corresponding to the zones you need to bypass. The LED zone indicators
should now indicate only the zones that require bypassing.
5. Once satisfied with your selection, press the [#] key to exit the bypass mode.
NOTE:
Panic zones cannot be bypassed – and remember that all bypassed zones are reset at every panel
disarm cycle.
9.
9. 9.
9. Emergency Alarms
Emergency AlarmsEmergency Alarms
Emergency Alarms
9.1
9.1 9.1
9.1 Fire Alarms
Fire AlarmsFire Alarms
Fire Alarms
Hold down the [F] key until the beep
1. If the [F] key is pressed until the keypad beeps (approximately 1 second) a FIRE ALARM condition
will be activated.
2. The FIRE ALARM condition may also be triggered by a smoke detector connected to an
appropriately programmed zone.
3. The siren will sound on and off repeatedly if programmed and the FIRE REPORTING CODE will be
transmitted to the monitoring company.
4. To silence the siren enter a valid [USER CODE].
9.2
9.2 9.2
9.2 Panic Alarms
Panic AlarmsPanic Alarms
Panic Alarms
Hold down the [P] key until the beep
 If the [P] key is pressed until the keypad beeps (approximately 1 second) a PANIC ALARM
condition will be activated.

IDS 816 Specifications

General

Brand	IDS
Model	816
Category	Keypad
Language	English