Stay Arming
This allows the user to arm the perimeter zones while disabling the interior zones so that
it is possible to remain on the premises. If zones are likely to be violated accidentally,
they should be programmed as BUZZ zones (refer to page 19). The panel can be
programmed with two different STAY PROFILES to be used as required.
Example of where this may be used:
Assume a property has perimeter sensors to secure a garden fence and a number of
internal sensors within each room of the house.
The first STAY PROFILE would function as follows: At night while you are within the
house going about your normal evening activities it may be desirable to activate the
alarm such that any violation of the perimeter sensors will cause an alarm.
Therefore, this profile would have all internal sensors programmed as STAY zones
(bypassed) and perimeter sensors would be normal alarm zones.
A second STAY PROFILE would then be utilised once the family retires to their
bedrooms. All bedrooms would therefore be STAY zones (bypassed) while unused
zones i.e. a lounge and TV room, together with perimeter zones would be normal
alarm zones.
NOTE:
Once a particular stay profile is selected, the system will use the selected profile each
time the system is armed into the STAY MODE. If the alternate profile is required, it is
necessary to select the alternate profile before the system is armed.
STAY and BUZZ zones can be programmed for each profile once the profile has been
entered.
To Select a Stay Profile
There are two stay profiles that can be configured, depending on your requirements.
There are two ways to change stay profiles.
When the system is disarmed follow these steps:
+ + + or +
1. Press the [#] key to clear any previous entries.
2. Press [MODE].
3. Press [9] then press [1] or [2] for the required profile.
4. Press [*] to enter. A long beep should be heard.
5. Program STAY and BUZZ zones for the profile or ARM the profile (See sections 12
and 13).
When armed in the stay mode follow this method:
+
1. Press [#] key to clear any previous entries.
2. Press [5] for 3 seconds and the stay profile will switch to the next stay profile.
To Next Page
Loading...
Need help?
General
