Arming the System
There are various options for arming the system
Away Arming
[#] + [USER CODE]
(Leave via Entry/Exit Zone)
1. Ensure that the Ready icon is on; if not, check that all protected doors and
windows are closed and that motion has ceased in areas with motion detectors.
2. If necessary, close the front door.
3. Press the key to cancel any unintended key entries.
4. Enter a valid 4 digit [USER CODE] . If you make a mistake,
press the key and re-enter the code.
5. The ARMED icon will come on and the keypad will beep for the duration of the
exit delay. A steadily lit zone indicator will show any bypassed zones.
6. The arming process has begun. Leave only via the Follower and Entry/Exit zones.
7. The panel will arm at the end of the exit delay.
Quick Away Arming
Hold down the key until the beep
If this function is enabled, it is possible to AWAY arm by simply holding down the
key until the keypad buzzer sounds and the arming process begins.
To Next Page
Loading...
Need help?
General
