EasyManuals Logo
Home>IDS>Control Panel>IDS806

IDS IDS806 User Manual

IDS IDS806
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Owner’s Manual
700-624-01C
15
If four incorrect user codes are entered consecutively while either arming or
disarming the system, the keypad will be non-responsive for 30 seconds. Your
monitoring company will also be notified on a keypad tamper.
NOTE:
1. If the ARMED indicator is flashing upon entry, there has been a violation. The
intruder may still be inside! Call for assistance.
2. If a strobe (or flashing light) has been installed and an alarm condition is registered,
the light will continue flashing until a valid [USER CODE] is entered.
To Disarm with a Remote Control
1. Press the arm/disarm remote button.
3. The system will disarm and the arm/disarm indicator (if installed) will turn off.
4. If programmed to do so, the siren will sound briefly - verify with your installer.
Emergency Situations
Fire Alarm
Hold down the key until the beep
If the [F] key is pressed until the keypad beeps (approximately 1 second) a FIRE
ALARM condition will be activated.
The FIRE ALARM CONDITION can also be triggered by a smoke detector connected
to an appropriately programmed zone.
The siren will sound (1 second on, 1 second off) and the FIRE REPORTING CODE
will be transmitted to the monitoring company.
To silence the siren enter a 4 digit [USER CODE]. The siren will stop sounding after
10 minutes if no user code is entered.
Panic Alarm
Hold down the key until the beep
If the [P] key is pressed until the keypad beeps (approximately 1 second) a PANIC
ALARM condition will be activated.
Any FIXED PANIC or REMOTE PANIC buttons which may have been installed can
also activate a PANIC ALARM.
If audible panic option has been selected, the siren will sound. A PANIC
REPORTING CODE will be transmitted to the monitoring company.
To silence the siren, enter a valid 4 digit [USER CODE]. If the siren is not cancelled,
it will stop automatically after the programmed SIREN TIME OUT period.
Ensure that your installer has enabled this function if it is required.
Press this key only in an emergency situation that requires response by
emergency personnel.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the IDS IDS806 and is the answer not in the manual?

IDS IDS806 Specifications

General IconGeneral
BrandIDS
ModelIDS806
CategoryControl Panel
LanguageEnglish

Related product manuals