To Cancel Buzz Zones
+ [ZONE NUMBER] +
1. Hold down the [4] key until the keypad buzzer sounds. The AWAY indicator will flash
to show that the panel is armed in the Buzz zone programming mode.
2. Press the [NUMBER] corresponding to the BUZZ zone you wish to cancel.
3. The relevant zone indicator will turn off.
4. Repeat step 2 until all buzz zones are cancelled.
5. Press the [#] key to exit the buzz zone programming mode.
NOTE:
The system will automatically exit this mode after 60 seconds.
Chime Zones
The chime mode allows the user to monitor nominated zones while the system is
disarmed. The keypad buzzer will sound 5 times when the nominated zone is violated -
the siren will NOT sound and no alarm condition will be reported.
EXAMPLE:
You wish to know when someone enters or exits the front door; the keypad will beep
each time the door is opened if that zone is programmed as a chime zone.
To Program the Chime Zones
+ [ZONE NUMBER] +
1. Hold down the [2] key until the keypad buzzer sounds.
2. The AWAY indicator will flash to show that the panel is in the chime zone
programming mode.
3. To program a zone as a chime zone, press the key corresponding to that zone. The
zone indicator will come on.
4. Program any other zones you wish to select as chime zones as per step 3.
5. Press the [#] key to exit the chime programming mode.
To Cancel the Chime Zones
+ [ZONE NUMBER] +
1. Hold down the [2] key until the keypad buzzer sounds.
2. The AWAY indicator will flash to show that the panel is in chime programming mode.
3. To cancel any chime zones, press the key corresponding to that zone. The zone
indicator will turn off.
4. Repeat step 3 until all the chime zones are cancelled.
5. Press the [#] key to exit the chime programming mode.
NOTE:
The system will automatically exit this mode after 60 seconds.
To Next Page
Loading...
Need help?
General
