IKONIX apt 400XAC Series User Manual

110
TDL1L2Q?
Testing Q meter
See Note3-1
TDL1L2VA?
Testing VA meter
See Note3-1
VAR
TDL1N?
Read the selected L1-N meter values while a test is in process.
TDL2N?
Read the selected L2-N meter values while a test is in process.
TDL1L2?
Read the selected total (L1-L2) meter values while a test is in process.
RDL1N XX?
Read the selected L1-N results once a test has completed.
RDL2N XX?
Read the selected L2-N results once a test has completed.
RDL1L2 XX?
Read the total (L1-L2) results once a test has completed.
8.4.4 Program Commands and Companion Queries
These commands are used to modify individual test parameters within each step.
Many of these commands require a parameter value to be included with the
command. The companion query command will read the parameter. The writing
of the parameter requires that the unit not be included with the value, only the
numeric value should be included with the command. Also, when the query
commands are sent, the response will not include the unit characters.
Command
Description
AC Program Mode
AC Manual
Mode
DC Program
Mode
DC Manual
Mode
Unit
NAME XXXX
MEMORY NAME
XXXX
XXXX=1~10 BYTES
NAME?
MEMORY NAME?
SAG XXXX
START ANGLE
XXXX
XXXX=0-359
°
SAG?
START ANGLE?
0-359
°
EAG XXXX
END ANGLE XXXX
XXXX=0-359
°
EAG?
END ANGLE?
0-359
°
MC XXXX
MEMORY CYCLE
XXXX
XXXX=0~9999,
0=Continue, 1=OFF
XXXX=0~9999,
0=Continue, 1=OFF
MC?
MEMORY CYCLE?
0-9999
0-9999
MEMORY X
MEMORY X
X=1-50
MEMORY?
MEMORY?
1-50
STEP X
STEP X
X=1-9
X=1-5
STEP?
STEP?
1-9
1-5

IKONIX apt 400XAC Series Specifications

General

Brand	IKONIX
Model	apt 400XAC Series
Category	AC Power Distribution
Language	English