Now press the Load soft key, which will load the memory and bring you back to
the set screen with the current memory and its parameters. If you press the Exit
soft key you will be brought back to memory screen, and if you press the Exit soft
key again you will go back to the Set screen.
4.4.2 Naming a Memory
To name a memory location you will need to press the <more> soft key when in
the memory screen.
Now press the Name soft key. This will bring you to the character map for
entering the memory name. The numeric keypad is also available for creating a
memory name. Press the <top> soft key to use the > soft key and soft key.
Press the Select soft key to choose your characters. If you use the numeric
keypad the character will be entered automatically when the keypad is pressed.
To delete a character use the <- - key on the numeric keypad. The memory name
can not be longer than 10 characters. The screen will look as follows:
Now press the <more> soft key which will bring you to the following screen:
To Next Page
Loading...
Need help?
General