4.6.10 Editing Trans-Time* (PROGRAM Mode only)
Use the , soft keys to navigate to the Trans-Time parameter (only selectable
for AC output). Pressing the Edit soft key will provide the following screen:
Trans-Time = indicates the Transient time that is programmed into the instrument.
Transient Pulse Width Range: indicates the Transient pulse width range that can
be programmed into the instrument.
To change the Transient pulse width use the numeric keypad and type the time.
Once you type in a number a shaded black box (■) will begin blinking
acknowledging the parameter is being changed. Press the Enter soft key to
accept the time, or press the Esc soft key to move back to the Trans-Time
parameter screen. When the Enter soft key is pressed the time is accepted and
you transition into the next parameter: Trans-Cont.
If you wish to bypass editing this parameter and move to the next parameter you
can press the Prev or Next soft key.
*Parameter is only available if the Transient parameter is turned ON.
4.6.11 Editing Trans-Cycle* (PROGRAM Mode only)
Use the , soft keys to navigate to the Trans-Cycle parameter (only selectable
for AC output). Pressing the Edit soft key will provide the following screen:
Trans-Cycle = indicates the Transient mode that is programmed into the
To Next Page
Loading...
Need help?
General