15
STV50 ed 09/08 VICTRIX 50 Rev. 002
Air inlet and exhaust systems.
(see air inlet and exhaust terminal instructions).
VICTRIX 50 boilers are type approved for installation outside
and inside a heating station.
e “VICTRIX 50” boiler leaves the factory with a “B23”
type conguration (fan-assisted open chamber); to change the
conguration into a “C” type (fan-assisted sealed chamber) you
have to remove the 80 Ø adapter, the bracket and the seal on
the boiler cover so you can then use the specic kits.
For a correct installation of the VICTRIX 50 boiler it is neces-
sary to use the new and specic set of air inlet and exhaust
pipes that have been designed to be used exclusively with the
VICTRIX 50 series of condensation boilers.
e ue pipes of the “GREEN SERIES” are made of plastic
(PPS = self-extinguishing polypropylene) suitable for resisting
the corrosive action of acid condensation as they are specic
for this kind of appliance.
Fan-assisted sealed chamber conguration
(type C).
Air inlet.
e vacuum that is created when the fan is working allows
the inlet of combustion air through the external concentric
hole (125 Ø) of the concentric adapter (2) slotted into the
draught diverter (1) which is connected to the fan with a
plastic pipe.
In this way air inlet of the air occurs outside the room where
the boiler is installed.
Exhaust.
Likewise, the discharge of the products of combustion occurs
by exploiting the narrowest hole (80 Ø) on the draught diverter
(1) which, by means of the concentric adapter (2), is coupled
to the concentric air inlet and exhaust ues.
In this way the ue are expelled outside the room where the
boiler is installed.
Technical Documentation
Technical Documentation
To Next Page
Loading...
Need help?
General