Indel Webasto Marine BI41 Dual User Manual

User Manual
21
5.1 Installaon
Isotherm products have been designed and constructed exclusively for recessed Isotherm products have been designed and constructed exclusively for recessed
installaon. installaon.
WARNING! The product must be installed horizontally and the compressor WARNING! The product must be installed horizontally and the compressor
must always be installed with its rubber feet resng downward. must always be installed with its rubber feet resng downward.
The compressor is capable of funconing at angles of up to 30°.The compressor is capable of funconing at angles of up to 30°.
WARNING! The compressor can become damaged with any higher WARNING! The compressor can become damaged with any higher
inclinaons. inclinaons.
Also remote operaon compressors must be installed with its rubber feet resng Also remote operaon compressors must be installed with its rubber feet resng
downward.downward.
Secure the product so that it cannot p/slide in the event of rough seas or in the case Secure the product so that it cannot p/slide in the event of rough seas or in the case
of sudden vehicle movement. The product should be anchored by at least 2 fastening of sudden vehicle movement. The product should be anchored by at least 2 fastening
points, in accordance with the provisions of the EN 60335-2-24 standard.points, in accordance with the provisions of the EN 60335-2-24 standard.
The covers supplied with the product (Fig. 3B) are insulated and provided with The covers supplied with the product (Fig. 3B) are insulated and provided with
special gaskets so as to ensure correct funconing of the product and to maintain the special gaskets so as to ensure correct funconing of the product and to maintain the
correct temperature, but they are not nished on the surface and are not provided correct temperature, but they are not nished on the surface and are not provided
with hinges or handles.with hinges or handles.
Install cladding for covers (not provided by Indel Webasto Marine Srl) as illustrated in Install cladding for covers (not provided by Indel Webasto Marine Srl) as illustrated in
(Fig. 3A), fastening any hinges and/or handles on the cladding.(Fig. 3A), fastening any hinges and/or handles on the cladding.
WARNING! Make sure that the cover has been properly closed, check that WARNING! Make sure that the cover has been properly closed, check that
the gasket is sealed properly on the trunk.the gasket is sealed properly on the trunk.

Indel Webasto Marine BI41 Dual Specifications

General

Brand	Indel Webasto Marine
Model	BI41 Dual
Category	Refrigerator
Language	English