www.insigniaproducts.com
30
Using the oven light
The oven has a light that is located on the rear oven wall in the upper left rear corner.
•Touch the Oven Light pad to turn the light on or off. The oven light lets you check the cooking progress without
opening the oven door.
Tips for baking
• Use appropriate non-stick coated metal sheets or aluminum containers or use heat-resistant silicone molds.
• Make the best use of the space on the rack. We recommend placing the baking pan in the middle of the rack.
• Select the correct shelf position before turning the oven on.
• Do not move oven shelves when hot. If you must move a rack while the oven is hot, do not the let the potholder
contact the hot oven element.
• Keep the oven door closed as much as possible.
Setting the clock
The clock must be set to the correct time of day for the automatic oven timing functions to work correctly. You can adjust
the clock to show a 12-hour or 24-hour display. The 12-hour display is the default setting. The time of day can only be
changed when your range is not in use (standby).
1 Press the (clock set) pad for three seconds.
2 Enter the current time in hours and minutes using the number pads. The time you set blinks on the display.
3 Touch the AM/PM pad to change between AM/PM.
4 Press the Start or Clock Set* pad to save. The display shows the time of the day.
Selecting the 12-hour or 24-hour display setting
1 Press and hold the AM / PM pad three seconds.The display shows the present mode.
2 Press the AM / PM pad to change between the 12-hour and 24-hour display setting. The display shows 12Hr or 24Hr
depending on your selection.
3 Press the Start pad to save the clock display mode.
Using the timer
The timer serves as an extra timer that beeps when the set time has elapsed. It does not start or stop cooking functions.
You can use this function at the same time as any other oven function or even when neither the cooktop or oven are in use.
You can set the timer for any amount of time from 1 minute to 23 hours and 59 minutes.
1 Press the Timer On/Off pad. The display shows Timer, and 00:00 blinks in the display.
2 Use the number pads to enter the amount of time you want in minutes or hours and minutes. The display shows the set
time.
3 Press the Start pad to start the timer. The display shows the remaining time. When time has elapsed, the timer
continues to beep until you press the Timer On/Off pad. After you press the Timer On/Off pad, the display shows the
time of day.
To Next Page
Loading...
Need help?
General
