Insignia NS-RGFCES2 User Manual

www.insigniaproducts.com
49
4.8 Cu. Ft. Electric Convection Range with Self Clean and Air Fry
Error codes
Turning demo mode on or off
When your range is in demo mode, most of its functions don't work.
• To turn off demo mode, press and hold the 1 and 9 number pads on control panel simultaneously for three seconds,
then release. OFF SHOP appears on the display for one second, then your range resumes its normal mode of operation.
• Repeat to turn demo mode on. ON SHOP appears on the display for one second, then your range enters demo mode.
ERROR CODE POSSIBLE CAUSE SOLUTION
E0 Oven temperature detection circuit
failure.
Press Off/Clear, then restart the oven. If
the problem persists, disconnect all power
to your range for at least 30 seconds, then
reconnect the power. If this does not solve
the problem, call for service.
E1 After the oven starts to heat up, the
temperature rises very slowly.
E2 Oven door switch detection failure.
E3 The oven cannot be heated.
E5 The oven’s normal cooking
temperature exceeds 650° F (343° C).
E8 Communication failure between
display board and main control board
E9 The main control board AC main
power frequency detection failure.
E10 The oven cannot be locked or
unlocked.
E11 Main control board CPU internal
failure.
E12 Display board CPU internal failure.
E13 When oven is working, the ambient
temperature of the main control
board PCB is too high.
E14 The ambient temperature detection
NTC circuit of the main control board
PCB is faulty.
E15 The software information of the main
control board and the display board
do not match.
E16 After the oven is locked, the oven
door can be opened or the detection
circuit that locks the door in place
fails, causing the door to not be
securely locked.
E17 The cooling fan motor speed
detection circuit is faulty.
E18 Communication failure between the
touch chip of the display board and
the CPU.

Insignia NS-RGFCES2 Specifications

General

Brand	Insignia
Model	NS-RGFCES2
Category	Convection Oven
Language	English